Tel: +86-576-82320996
Email: wanda@tzwd.cn
Categories
Contact Us

Taizhou Wanda Cord and Cable Co.,Ltd

Address:Aohou Tongyu Street, Luqiao Disctrict, Taizhou City, Zhejiang, China

Tel:+ 86-0576-82320996

M/P:+86-13957675080

Fax:+ 86-0576-82335700

E-mail:wanda@tzwd.cn

News
Home > News > Content

Electric Tiller Necessary Adjustments

Taizhou Wanda Cord and Cable Co.,Ltd | Updated: Sep 29, 2017

Electric Tiller Necessary adjustments

Electric tillage machine after the operation, to timely the necessary tightening and parts adjustment, electric tillage machine used in some places for some time, some parts of the gap will increase, the user should make the necessary adjustments.

Electric tillage machine manufacturers that part of the electric tillage machine clutch, reverse gear, throttle, steering and so are through the cable operation, and the cable is easy to deformation and elongation, so by adjusting the screw in time to adjust.

There are gears of the shaft of a shaft, two-axis, two pairs of conical gears and other use for some time, will have a certain gap, a shaft, two shafts through the tight back screw to adjust the two tapered gears by increasing the steel Gasket to adjust.

Electric tillage machine manufacturers to remind the use of the process, every day to carry out the necessary fastening. But to pay special attention to is that the engine screws do not easily tighten it, mainly those directly on the aluminum alloy shell screws. 1, electric tillage machine operators must go through professional training or familiar with the machine after the instructions can be operated, not familiar with the operation of the aircraft personnel is strictly prohibited operation.

2, electric tillage machine operators should pay special attention to the safety warning signs on the machine, carefully read the contents of the logo, and express other operators.

3, electric tillage machine operators should pay attention to prevent the movement of parts caused by injury. To check whether all exposed rotary parts have been well protected.

4, electric tillage machine operator is strictly prohibited fatigue work, so as to avoid accidents. 5, electric tillage machine manufacturers to remind each time before the work must check the engine and gearbox lubricants are sufficient.

6, before use must check the parts and gearbox, the engine bolts are loose, off the phenomenon.

7, check the operating parts (bit) is flexible and effective.

8, the installation of a knife, you must confirm the left and right symmetry, working edge facing forward, or can not be used normally.

9, the engine must be checked before the start of the clutch in the separation position, whether the shift lever into the neutral position.

10, electric tillage machine manufacturers to ensure the normal work of the engine to extend its service life, the engine must be empty after the start of operation, hot car 5 to 10 minutes before work, start working 1 to 2 hours before the best not to high speed and weight Load work. If the engine starts when the phenomenon of speed, should be quickly cut off the oil supply or plug the engine to immediately turn off the engine.

11, the height of the resistance bar according to the work at any time to adjust to maintain the level of the fuselage to prevent excessive tilt due to the engine, resulting in poor engine lubrication and damage.

12, the operation process should be prohibited to touch all kinds of rotating knives, to avoid injury, and away from the exhaust pipe high temperature area, careful burns.

13, in the replacement of tools, removal of weeds and inspection and maintenance, the engine must be stopped after the operation can be carried out.