Tel: +86-576-82320996
Email: wanda@tzwd.cn
Categories
Contact Us

Taizhou Wanda Cord and Cable Co.,Ltd

Address:Aohou Tongyu Street, Luqiao Disctrict, Taizhou City, Zhejiang, China

Tel:+ 86-0576-82320996

M/P:+86-13957675080

Fax:+ 86-0576-82335700

E-mail:wanda@tzwd.cn

News
Home > News > Content

Vertical Shaft Tiller Operational Knowledge

Taizhou Wanda Cord and Cable Co.,Ltd | Updated: Sep 12, 2017

Vertical Shaft Tiller Operational knowledge

Analysis of common operation of vertical axis tiller

 1, vertical axis farming machine operators must go through professional training or familiar with the machine after the instructions can be operated, not familiar with the machine operating methods of personnel is strictly prohibited operation.

   2, vertical axis farming machine operators should pay special attention to the safety warning signs on the machine, carefully read the contents of the logo, and express other operators.

      3, vertical axis farming machine operators should pay attention to prevent the movement of parts caused by injury. To check whether all exposed rotary parts have been well protected.

      4, vertical axis farming machine operator is strictly prohibited fatigue work, so as to avoid accidents.

      5, each work must be checked before the engine and the transmission box is sufficient oil.

      6, before use must check the parts and gearbox, the engine bolts are loose, off the phenomenon.

       7, check the operating parts (bit) is flexible and effective.

       8, the installation of a knife, you must confirm the left and right symmetry, working edge facing forward, or can not be used normally.

       9, the engine must be checked before the start of the clutch in the separation position, whether the shift lever into the neutral position.

      10, in order to ensure the normal work of the engine to extend its service life, the engine must be empty after the start of operation, hot car 5 to 10 minutes before work, start working 1 to 2 hours before the best not to high speed and heavy load work. If the engine starts when the phenomenon of speed, should be quickly cut off the oil supply or plug the engine to immediately turn off the engine.

      11, the height of the resistance bar according to the work at any time to adjust to maintain the level of the fuselage to prevent excessive tilt due to the engine, resulting in poor engine lubrication and damage.

      12, the operation process should be prohibited to touch all kinds of rotating knives, to avoid injury, and away from the exhaust pipe high temperature area, careful burns.